■ Installation of objects

-Drag points are set on the screen based on your feet.

■ Camera operation

・ Basic operation of the camera

With non-model selected

-Camera rotation: Right mouse click and drag

-Camera movement: Drag the mouse wheel button

-Zoom camera: Drag left mouse click

・ Lock the camera

Lock the camera so that it does not shift when the camera angle installation is complete.

■ Fine layout model adjustment

・ If the layout has not been decided yet, unlock the camera and make adjustments while moving the perspective view of the four views as much as possible.

This allows you to move the 3D layout without shifting the camera angle on campus.

 

The perspective view of the four views can be made into one screen by dragging.

-Speed up edit display settings

Since it takes time to move the object in the default state, set the edit display setting to "high speed".

In the "normal" state, you can check the layer effect in real time in the layer properties.

■ Object selection / duplication, etc.

You can move / copy, paste / delete multiple items by selecting while pressing shift.

■ Drag 3D to the ruler

・ How to place a 3D object in a two-point perspective picture

-Normally, 3D models can only be dragged to a 3-point perspective perspective.

So, to place a 3D object on a one-point diagram, first make a two-point perspective perspective ruler and then

I will make a pseudo three-point perspective.

 

The method is simple.

 

The first two points usually determine the vanishing point,

b. Hold down the shift vertically and pull twice for the vanishing point of the next 3rd store.

By doing this, a pseudo-appearance 3-point perspective perspective ruler with 2-point perspective is created.

 

Let's place an object on this ruler layer.

The camera angle object that you learned from the perspective ruler should be placed.

 

As a caveat

After it's done, use the rotation button on this 3D layer camera

Please note that the perspective specified earlier will be misaligned.

 

・ Determine spatial standards

-The final packing of the 3d object placement generated from the perspective ruler.

 

First, write the reference height on a wall or the like. (As an example, the model woman is about 159 cm, so draw a line about 159 cm on the wall.)

 

Then make sure the 3D fits the height of the line

Try adjusting with the camera's zoom and pan.

 

At this time, the width of the grid line displayed below when moving in 3D is 50 cm, so

I think you can try to fit this 50 cm.

 

Then, even if you try to move the object by pressing the object move button after this

The object should move beautifully according to the drawn space.